Beach & Boardwalk Collab

Beach & Boardwalk Collaborative Build

Overview

Full Article:

One “Module” consists of (3) 32x32 baseplates:

  • (1) deep ocean baseplate
  • (1) ocean/sand baseplate and
  • (1) boardwalk baseplate
  • Each of these are stacked vertically and will be set next to each other to create strips of ocean, beach, and boardwalk

Overall Notes

  • Would love some Discord/email discussion to see if we want to consider some “shared” bulk Bricklink, PAB wall, or PAB LEGO.com orders to get wide access to parts needed.
  • I have mocked up all of these in Studio, so please reach out if you’d like that file for review or discussion.

Plate 1: Deep Ocean

Standard Requirements

  • (1) 32x32 baseplate covered in black plate for the first 20 studs (left to right), then blue plate for the remaining 12 studs.
    • The color change represents water depth and can vary up to 8 studs in either direction,
    • This can vary as you wish internally, but exit points from your stretch of plate should be at these positions so they can attach to other builders.
    • Builders with multiple modules may alter the entry/exit as they wish within the span of their modules
  • Cover the first layer of plates with 1x2 Trans Light Blue tiles in a stitched (1 stud offset) pattern which begins with odd rows indented 1 stud and even rows touching the edge.

    This photo demonstrates the stitched pattern, but note it is from Plate 2, not Plate 1 which is black plate fusing into blue plate only.

    This photo demonstrates the stitched pattern, but note it is from Plate 2, not Plate 1 which is black plate fusing into blue plate only.

  • The entire plate is 2 plates high total: one layer of deep water plate (black, then blue) and one layer of 1x2 trans light blue tiles.

Standard Suggestions & Notes

  • Due to the concern of laying 1x2 tiles and the difficult of “unstitching them,” builders should fill in the empty 1x1 space with 1x1 Trans Light Blue Tiles.


Powered by Admidio © Admidio Team